Better than an extra pair of hands in the shop, because extra hands can’t guarantee your stock is being held square!
Woodpeckers Box Clamps hold your box and case good projects perfectly square while you check joinery, do layout work, or install fasteners. The clever low-profile wedge system forces the corner square, even if the two sides are different thicknesses (up to 6.4mm difference). Woodpeckers Box Clamps are made using a nearly indestructible glass-fibre reinforced polycarbonate. They can accommodate stock from 6.4mm to a full 25.4mm.
Each box clamp comes with both knobs and hex head bolts, to use the Box Clamps two different ways. You can rest it flat on a table (or even mount it) or change the clamping bolt, add a knob and use it as a hand-held clamp on the upper sections of your project. The change from one mode to the other takes just seconds.
These clamps work great on butt joints, mitres, dadoes, rabbets, T-joints, dovetails and box joints…even when material overhangs the joint face. Its open design lets you easily nail or screw along the full length of the joint.
You can glue-up or dry-fit any 90° joint quickly and easily. Just position the fixed block using the scale moulded right into the base, then, as you tighten the clamp, equal pressure is applied to both parts and they’re pulled into perfect 90° alignment. It’s that simple.
Like all Woodpeckers products, the Box Clamps are precisely built and carefully inspected in Woodpecker’s Strongsville, Ohio factory (just south of Cleveland).
Please note: although products are metric, the photos may depict imperial versions.