Armor Tool 20mm x 76mm Post for Auto-PRO Bench Dog Hold-Down Clamp

Armor Tool's Horizontal Toggle Clamp is the first truly revolutionary hold-down clamp to have been released in the 21st century.

This serrated 20mm bench dog post which grips into the dog hole very securely - allowing greater clamping pressure to be applied without slipping. 

Traditional hold-downs have the same long post for standard dog holes, however suffer from having to turn a knob until the desired clamping pressure is achieved. Not Armor Tool's! Just adjust the post roughly close to where it should be, then push the clamp handle down to lock the clamp in position over the work piece. It is literally a snap!

Different Post Sizes Available

There are three different post sizes to suit both Auto-PRO Bench Dog Hold-Down and Inline Clamps. The different post sizes are  -

1. 20mm diameter x 190mm long - provides the same height range as the standard 19mm version but will work in European work table systems such as the Festool MFT table.
2. 20mm diameter x 76mm long - provides requirement for less clearance under the table when using smaller work pieces in European work table systems such as the Festool MFT table.
3. 19mm diameter x 76mm long - provides requirement for less clearance under the table when using smaller work pieces on standard 3/4in (19mm) dog hole benches.