Sherwood Cast Iron Router Extension Wing with Fence for Table Saws 685 x 406mm

The Sherwood Router Table Extension Wing is an industrial masterclass

Please note: These kits are designed to fit most cast iron table saws. Table saw is not included.

Also available as a Deluxe Kit with Plunge Router Lift or Round Body Motor & Mounting Plate.

The Sherwood 685 x 406mm cast-iron router top can be mounted directly to most table saws with a 685mm (27in) table depth, or with minimal compromise on larger saws. Shown here with a full router lift and dust box attached to a TS-250-SL-30-F cabinet saw, it transforms unused space into a high-performance routing station.

Installation is straightforward using the included hardware: simply align the pre-cast holes in the router wing, mark and drill your saw’s cast-iron edge (a 16mm twist drill is recommended for alignment), then secure with the supplied M12 bolts. While some saws may require alternative hardware, once mounted, the router wing becomes a solid, integrated extension of the saw.

What's Included?

• 685 x 406mm Cast Iron Table Top
• 685mm Super-Flat Fence
• Aluminium router nmounting plate
• Remote switchbox and mount bracket
• Most necessary mounting hardware

PLEASE NOTE: some hardware is included but may not suit your table saw so some may need to be provided to complete installation

Installation & Use Advice

1. Due to the extra mass being hung from the side of the table saw, there may be a possibility that the whole saw could tilt and fall over. We recommend mounting some simple legs to the side of the saw that this table is mounted to in case tipping is likely - especially if the package is installed to the right-side of the blade.
2. You will need to mount and remove the router fence every time you swap between the sawing and routing modes (using as a table saw or using as a router table).
3. At this stage it is not possible to fit the fine adjustment assembly kit due to the mounting configuration.